Personal mobility

How to Measure Your Skateboard Speed With an iPhone

Find out how fast you skate with iPhone GPS: where to carry the phone on a board, recording a run before you push off, and why short bursts can read low.

The GPS Speedometer team · Apprexy StudioPublished 6 min read

Your iPhone can tell you how fast you skate using its built-in GPS: start a recording in a speedometer app, put the phone away in a zipped pocket or an armband, ride, and read your top and average speed once you've stopped. You don't hold the phone or look at it while rolling. The numbers are most trustworthy on longer, steady runs; quick pushes and short bursts tend to read a little low.

Why a skateboard is an awkward place for a phone

Most vehicles give a phone somewhere to live. A car has a dashboard, a bicycle has handlebars, a boat has a console. A skateboard has none of that. There is nothing to mount a phone on, and your hands need to be free for balance, for pushing off and for catching yourself if you fall.

That changes how you measure. With a skateboard, the phone is a recorder, not a dashboard. You set it running, stow it, skate, and look at the results afterwards. The live number on the screen matters far less than the trip log you review at the end.

It also changes what can go wrong. A phone carried in a hand or a loose pocket can fly out on a fall or a sudden stop, and a cracked screen is the smaller risk; reaching for a slipping phone while moving is the bigger one.

Where to carry the phone while you skate

Pick a spot where the phone is closed in, sits close to your body and can't shift around:

Option Good for Watch out for
Zipped jacket or trouser pocket Everyday cruising and commutes Open pockets; tight jeans that press on the screen
Running armband Longer sessions and warm weather A loose strap that slides down the arm
Zipped waist pack worn close to the body Carrying keys and phone together Bags that swing as you carve
Backpack, top pocket Commuting with gear Buried deep inside, the signal can be weaker

Whatever you choose, close it before you step on the board. Holding the phone, or holding it up to film yourself while riding, is the setup to avoid: it takes a hand away from balance and draws your eyes off the ground.

Setting up the skateboard profile in GPS Speedometer

GPS Speedometer reads speed from the iPhone's own GPS, so there is nothing to attach to the deck or trucks. Do the setup standing still, with the board under your arm or on the ground beside you:

  1. Allow location access when the app asks. If readings seem coarse later, check that Precise Location is turned on for the app in Settings › Privacy & Security › Location Services (on older iOS versions this sits under Privacy).
  2. Choose the skateboard vehicle profile.
  3. Choose km/h or mph. Knots are available too, but they are meant for boats.
  4. If you want a log of the session, tap record now. Trip recording, with distance, max and average speed, drive time, a speed chart and the route, needs Premium. The live readout with the Digital Clean gauge is free.
  5. Lock the phone and put it away. Recording continues in the background, so the screen doesn't need to stay on.

A simple session plan: record, ride, stop, read

Treat each measurement as a short sequence with a clear start and end:

  1. Wait for a steady zero. Open the app outdoors, under open sky, and give GPS a moment to settle before you start.
  2. Start recording, then stow the phone. Both happen before your first push.
  3. Skate normally. Don't check your pocket mid-run. If the phone starts slipping, stop first, then fix it.
  4. Stop fully and step off somewhere out of the way of people and traffic.
  5. Read the results, then stop the recording.

If you want to compare runs, record each one separately. A single long recording that mixes rolling, carrying the board and waiting around makes the average hard to interpret.

Why GPS under-reads short skateboard bursts

GPS doesn't sense the wheels. It works out your speed from how your position changes over time, and the phone smooths those changes so the reading doesn't jitter. On a steady cruise that smoothing barely matters. On a skateboard, a lot of riding is anything but steady.

  • A few hard pushes and a short roll may be over before the reading has caught up, so the peak you felt can show up lower in the log.
  • Pumping and carving produce quick rises and dips that get flattened out.
  • Tall buildings, underpasses and covered areas weaken the signal. Speed can freeze or wander, and a single bad position fix as the signal returns can create a spike that never happened.
  • Skateparks with high walls or roofs are hard for GPS for the same reason; indoor parks may give no useful reading at all.

The practical takeaway: longer, even stretches in the open give the most reliable figures, and a sudden spike next to a building is more likely an error than a record.

Gear, places and pace

A speed reading can make it tempting to push for a bigger number. That is worth resisting. Measure the riding you already do, rather than going faster to see what the app says.

As general, widely shared advice, a helmet is the first piece of protective gear, with wrist guards, knee pads and elbow pads adding protection, especially while you are learning or riding faster than usual. Check your wheels, bearings and trucks before a session.

Choose where you ride with care. Public roads and steep hills are not places to chase top speed: cars, junctions, gravel and the limits of your own stopping ability all count against you. Rules on where boards may be ridden vary by place, so check local guidance rather than assuming.

Reading your skateboard numbers afterwards

Once you have stopped and stepped off, open the trip. With Premium, GPS Speedometer shows distance, max and average speed, drive time, a speed chart and the route on a map.

  • Max speed is a single moment. Find it on the chart: if it is a lone spike beside a building or tunnel, it is probably a GPS glitch.
  • Average speed includes every slow push, stop and pause, so it will sit well below your cruising pace.
  • The speed chart is the best view of a session. Smooth plateaus are your steady rolling; short bumps are pushes that GPS may have flattened.
  • The route helps you spot where the signal dropped, such as a straight line cutting across a block.

Comparing the same route on different days is often more useful than chasing a single top figure.

FAQ

How fast am I skateboarding?

Record a run with the phone stowed and check the average speed over a steady stretch, plus the max on the chart. Cruising and pushing speeds vary a lot by rider, board and surface, so your own log is the best answer.

Can I measure speed with the phone in my pocket?

Yes. GPS works through fabric, and recording continues with the screen locked. A zipped pocket or armband close to the body works well; deep inside a full backpack the signal can be weaker.

Which GPS Speedometer features are free?

The app is free to download, and the live speed readout is free with the Digital Clean gauge. Premium unlocks the other gauge themes, HUD mode, trip recording and history, the speed-limit alerts, the drag timer and the Picture-in-Picture widget.

Does it work for longboards too?

Yes. Speed comes from the iPhone's GPS, not the board, so the skateboard profile suits longboards and cruisers as well. Longer, steadier runs on a longboard tend to give cleaner readings than short street pushes.

Written by the GPS Speedometer team with the help of AI. What the article says about GPS Speedometer comes from the app itself; menu names in other apps can change between versions.